Matching Results: Woodshop News
Hello Cosmo’s Design
(0)
I am checking in once again to my long dormant blog and website. I want to report that I am in the final two weeks of my degree and will be finished by the end of the month. I have had a grueling schedule and have had little time to even think about furniture or … [View Details]
I’m still alive
(1)
I wanted to check in and let everyone know that I am still alive and doing well. I am working very hard at school and am getting closer to graduation. I am taking 15 hours this semester and will have to take a similar load next semester to graduate in the spring. As you can … [View Details]
My latest plywood chair project
(0)
While I haven’t been doing much outside work, other than something for my church and some custom pieces for an old airplane, I have had some time to work on some of my own ideas. A while back I had an idea to use up some of the scrap wood that keeps piling up around … [View Details]
A short (I hope) sebatical
(0)
I’m sure you’ve noticed that I haven’t been too active on this blog for a little while, and if you have projects with me you have noticed that my pace has slowed down considerably. I am sorry for being absent for so long, but life is full of changes and mine has been going through … [View Details]
I Finally have time to breathe
(0)
School is finally over and my final project that consumed my time day and night for the last three weeks has been turned in. I finally have time to sit and think about other things, including the blog. I don’t have much time to rest though, I am starting a may-mester in a week which … [View Details]
Thanks Maria
(2)
Maria, the client for whom I designed and made the laminated console table, has sent me some pictures of the table in her house. They are awesome. I wanted to share this one picture in particular with everyone and thank Maria for her kindness in sending them. Enjoy.
Laminated Console Table: Final Part
(0)
I finally finished and shipped the laminated console table. I put a few more coats of shellac on the table. After two thick coats I sanded with 320 grit sandpaper and then applied two thin, hand rubbed coats to reach a more even finish. After doing a little bit of research and a lot of … [View Details]
Laminated Console Table Part VI
(0)
This has to be the most documented project I have ever done. I am learning, however, that is a good idea to have a record of your work if for no other reason than to prove, like in a portfolio, that you actually did the work. It also helps keep a record in case I … [View Details]
Laminated Console Table Part V
(0)
I was hoping that this would be one of the last posts about the table, but I keep running into road blocks. I let it sit on the table over the weekend and when I went out to the shop on Monday I noticed it had developed a crack. I worked Monday morning repairing the … [View Details]
Laminated Console Table Part IV
(0)
I finally finished the construction phase of the table! I laminated the legs, sanded them down, and drilled holes for pegs in the bottom of the table and the top of the legs. There needs to be a little more sanding so that the legs and table top line up a little better, but other … [View Details]
